-
Control Systems
control-systems
-
TCI-W22 Universal Controller
-
TCX2 Universal Controller
-
VP-3600
Application
Standard on-off control of room humidity and air temperature, where staged on-off control of cooling and heating is required. This control package is intended for a residential swimming pool applications, where remote monitoring might be needed (Internet connected router required - sold separately).
This control package is limited to only Air Cooled - Non Water Heating Assist Models.
-
De-Humidistat
Features
The model ST-201 De-humidistat is a wall mounted control that must be located in the space being dehumidified. It is 24 volt operated that is wired to the exterior low voltage panel on the dehumidifier by 2 low voltage wires.
Location
Mount control approximately 60 inches above the floor in freely circulated room air that is returning back to the dehumidifier. The location must not allow discharged dehumidifier to fall on it. Avoid locations near hot or cold sources from windows or doors or other HVAC equipment.
Operation:
Normal operation calls for the room humidity to be controlled between 50 and 60 percent RH differential built into the control. A rise of room relative humidity above the set point allows the dehumidifier to start and operate until the room relative humidity is lowered sufficiently below the set point at which time the dehumidifier stops. The control also offers a manual on or off mode.
